Other articles

  1. My Printers

    Fri 20 September 2019

    I have two ender 3, an anet a8 in pieces and most of a monoprice I'm rebuilding on RAMPS.

    read more
  2. rebuilding a monoprice mini with RAMPS

    Fri 20 September 2019

    Working on rebuilding a monoprice mini with ramps on an Arduino Mega.

    This was my first printer, it served admirably until the stock board went. Haven't been taking a lot of WIP photos, at this point it is pretty well wired up.

    • New RAMPS 1.1.4 on an arduino …
    read more

blogroll

social